Guide

How to disconnect a car battery: the order of the terminals and what happens afterwards

The ADAC procedure: negative first when disconnecting, positive first when reconnecting. What to do before, what may be lost after reconnecting, and when to leave a battery change to a workshop.

Before you start

Step by step: disconnecting

  1. Disconnect the negative (−), black cable.
  2. Disconnect the positive (+), red cable.
  3. Insulate the positive clamp, for example with insulating tape or a terminal cap (ADAC).

Why negative first: for motorcycles ADAC explains that this way a tool on the positive terminal cannot cause a short circuit when it touches the frame.

Step by step: reconnecting

  1. Connect the positive (+), red cable.
  2. Connect the negative (−), black cable.
  3. Fit the terminal cap. According to ADAC it prevents a short circuit.

For motorcycles ADAC advises fitting the clamps on clean, grease-free terminals and then protecting them with terminal grease.

What may happen after reconnecting

Disconnect the battery when the car stands for long?

Disconnecting stops the car's draw, but after reconnecting some functions may need setting up again. For motorcycles over winter, ADAC advises removing the battery, charging it fully and storing it cool, at about 10 °C. If the vehicle stands in a room above 10 °C, the battery may stay in, but no permanent consumer such as an alarm may be connected and at least the negative cable should be unscrewed. For a car, see Car in winter storage.

Replacing the battery

The terminal order is the same. Which battery type belongs in the car, the manual says (ADAC). According to ADAC, modern cars and many older start-stop cars often have battery management, which means the new battery has to be registered in the car with special equipment, and sometimes fault codes must be cleared too. ADAC therefore advises leaving a battery change to professionals as a rule and advises laypeople against it. Doing it yourself only comes into question on an older car without battery management.

Sources

Where QZ helps

QZ watches the battery voltage remotely, and fitting it does not need the battery disconnected (see How it works). While the battery is disconnected, QZ cannot watch it. While it is connected, QZ shows the voltage in the app and, while connected to the mobile network, alerts you about a weakening battery it detects. It does not start the car, does not charge the battery, cannot catch every fault and does not guarantee that the car starts.

Frequently asked questions

Which battery terminal comes off first? The negative. When reconnecting, the negative goes on last (ADAC). If your car's manual says otherwise, follow it.

Will I lose settings when I disconnect the battery? You may. According to ADAC the radio, alarm and other electronics may lose their settings, and sometimes fault codes must be cleared. Volvo says the pinch protection has to be restored.

Can I replace the car battery myself? ADAC advises leaving it to professionals as a rule and advises laypeople against it. Modern cars and many start-stop cars often have battery management that needs the new battery registered with special equipment. Doing it yourself only comes into question on an older car without battery management.

Car in winter storage: the battery

How to charge a car battery

Car battery lifespan

QZ sees more than the battery.
12 V battery
Interrupted power
Vehicle position
EU services
Discover QZ View →