Battery voltage

Car battery voltage chart: what 12.6 V, 12.4 V or 12.0 V means

One number on a multimeter tells you a lot, if you know when and how to measure it. Here is an overview for common 12 V lead-acid batteries (flooded, EFB, AGM, GEL), what the battery makers themselves say, and where voltage alone reaches its limits.

How to measure the resting voltage properly

The resting voltage only means something on a car that has been parked for several hours: after driving or charging, the battery shows a higher voltage for a while than its real state. Manufacturers do not agree on how long to wait: Banner gives 5 hours after charging, others up to 24 hours. The easiest is to measure in the morning after the car has stood overnight.

  1. Switch off the ignition and all consumers, and leave the car locked.
  2. Set the multimeter to DC voltage (20 V range).
  3. Put the red probe on the positive terminal and the black probe on the negative terminal, then read the value.

Chart: what the resting voltage tells you

Resting voltageWhat it means
12.6 V or moreThe battery is charged.
around 12.4 VPartly discharged. It often still starts the car, but the voltage does not guarantee it, especially in frost. Recharge.
around 12.2 VSignificantly discharged. Charge as soon as possible; the longer it stays there, the more it ages.
below 12.0 VCritically discharged. Starting is uncertain, the risk of permanent capacity loss rises, and in winter it can freeze.
above 13 V on a parked carThe battery is being charged (charger, solar panel), or not enough time has passed since driving.

The chart is a guide for common lead-acid batteries. According to the manufacturers, a fully charged AGM battery reads about 12.8 to 13.0 V once settled, so 12.6 V is already slightly below full for AGM.

What the battery makers say

Differences between manufacturers are normal, and the limits also vary by battery type. A sensible rule: below 12.5 V recharge, below 12.0 V recharge now.

Voltage with the engine running

With the engine running, the alternator should charge the battery. Older cars hold roughly 13.8 to 14.4 V. Newer cars with smart charging vary the voltage on purpose and at times do not charge at all, so a single reading proves nothing. If the voltage keeps falling while driving, have the charging system checked at a workshop.

Frost and voltage

In frost a battery delivers less starting power, so a partly discharged battery that starts the car in summer fails in winter. Frost barely harms a charged battery: according to the manufacturer Trojan, the electrolyte of a charged battery freezes only below −50 °C. A deeply discharged battery, however, can freeze at around −7 °C.

Hybrid and electric cars

The chart applies to a lead-acid 12 V battery in a hybrid or electric car too. It does not apply to a lithium 12 V battery, as noted above. Which type your car has is on the battery label or in the owner's manual.

Where voltage alone reaches its limits

The resting voltage shows the state of charge, not the battery's condition. It tells you nothing about capacity or cranking amps; that takes a load test at a workshop. And one reading is not a verdict: 12.4 V once after a short drive means something different from 12.4 V three days in a row with a falling trend. That is why QZ does not watch one number but how the battery behaves over time.

LiFePO4 (lithium) starter batteries have a completely different curve: at rest they sit above 13 V, and between 20 and 80 % charge the voltage changes by only a few tenths of a volt. This chart does not apply to them.

Where QZ helps

If you would rather not walk to the car with a multimeter, QZ measures the voltage for you directly at the battery and alerts you on your phone over its own 4G connection when it drops. It knows the battery type, so the alert follows the limits that apply to yours. QZ does not charge the battery.

How we measured

The figures from our own cars come from vehicles QZ monitors in everyday use. The unit is connected directly to the 12 V battery terminals and measures the voltage at regular intervals, also while the car is parked. We read the resting voltage only several hours after driving or charging. This is not a workshop test: QZ does not measure capacity or cranking amps. The full measurement methodology →

Frequently asked questions

What voltage should a charged car battery have? A common lead-acid battery reads 12.6 V or more at rest. According to the manufacturers, a fully charged AGM battery reads about 12.8 to 13.0 V. Measure on a car that has been parked for at least several hours.

Is 12.4 V still OK? The car often starts, but the battery is partly discharged. VARTA recommends recharging at 12.4 V, Exide and Banner already below 12.5 V. Left in this state for long, a battery ages faster.

Why does the battery show more than 13 V right after driving? After driving or charging the battery carries a higher surface voltage that falls gradually. Only a reading after several hours parked shows the real state.

Can the voltage tell me whether the battery is good? Only partly. Voltage shows the state of charge, not capacity or starting power. A load test at a workshop measures the battery's condition reliably.

Car won't start after sitting? Why, and what to do →

Battery keeps dying? The five causes →

All guides →

QZ sees more than the battery.
12 V battery
Interrupted power
Vehicle position
EU services
Discover QZ View →